Electronic Automatic Floor Spring , Under ground swing door motor

Electronic floor spring Automatic Floor Spring Under ground swing door motor

Opening angle:45degree to 135degree

l. Opening speed adjustable: 2-6s/ closing speed adjustable:3-6s

2. Work noise:Being smaller than 50 db

3. Hold open time adjustable: 0-30s

4. Power supply: 220 V±10% 50~60 HZ

5. Self-protection safety system: self protection against overheat, overvoltage, overcurrent, obstacle-encountering

6. Rated power: 35W static power: 3W

7. Output power: 12VDC, 0.5A, for sensor, entrance guard, push button and electric strike etc. 8. Applicable for single leaf swing door: max weight 120Kg, max width 1000mm

9. Size of Machine: 295mm(L)X 132mm(W)X 82mm(H)

Installation Notice

Door leaf max weight and width: max weight 120Kg, max width 1000mm

Installation measurement: The operator must be installed exactly as the measurements stipulated by the instruction manual, the improper installation will decrease the operation of the operator, even cause malfunction and damage. Make sure the the driving axis is in line of pivot.

Examine and repair exit:prepare the exit for examination and repair.

Glass door requirement: If you use the small door clip, the glass door width must be less than 900mm for safety, and the glass should be tempered.

Installation notice

1. 1. Pay attention to the position mark in the driving axis, the mark direction point to door leaf.
2. 2. Make sure the lintel size is enough.
3. 3. The driving axis should be in the vertical line of the bottom pivot, otherwise the door can not be opened or closed properly.
4. 4. Tighten all screws of door clips for 100% safety. If the door clip is loose, the operator can not identify the accurate door position and cause trembling.

Basic voltage distribution:

power:220V AC transformer:12V AC

motor voltage:16V DC controller voltage:5V DC

Standard Configuration